As the front doors are locked, the system will give you a preparation time of 30 seconds before the setting, during which the front, sliding and back doors and hood may be opened to prepare for the setting.

    Be careful not to use the key when opening either front door. This will cancel the system.

4. After making sure the indicator light starts flashing, you may leave the vehicle.

The system will automatically be set after the preparation time elapses. The indicator light will flash to show the system is set. If any of the front, sliding and back doors and hood is opened at that time, the setting is interrupted until it is closed and locked.

  Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate (使起动) the system.

WHEN THE SYSTEM IS SET

Activating the system

  The system will give the alarm and cut the starter circuit under the following conditions:

  If any of the front, sliding and back doors and hood is unlocked without using the key

  If the battery terminal is disconnected and then reconnected

  After one minute, the alarm will automatically stop with the starter circuit cut kept on.

Reactivating the alarm

  Once set, the system automatically resets the alarm each time the front, sliding and back doors and hood are closed after the alarm stops.

  The alarm will be activated again under the following conditions:

  If any of the front, sliding and back doors and hood is opened

  If the battery terminal is disconnected and then reconnected

Stopping the alarm

  Turn the ignition key from the “LOCK” to “ACC” position. The alarm will be stopped with the starter circuit cut kept on. Stopping the alarm in this manner will keep the alarm from being reactivated when any of the front, sliding and back doors and hood is opened.

Interrupting the setting

  With the system set, the back door can be opened with the key without activating or canceling the system. While it is open, the front and sliding doors and hood may be opened in addition, and the system can be activated only by the battery terminal disconnection.

  To resume the setting, close and lock the front, sliding and back doors and hood. The back door must be closed with the key removed.

CANCELLING  THE  SYSTEM

  Unlock either front door with the key, or unlock the sliding door with the key when it has been closed. This cancels the system completely and the starter circuit cut will be cancelled at once.

INDICATOR  LIGHT

The indicator light gives the following three indications when the system is in use. When the light is:

  FLASHING—The system is set. You need the key to open the front, sliding and back doors and hood.

  ON—The system will automatically be set when the time comes. The front, sliding and back doors and hood may be opened without a key.

  OFF—The system is inactive. You may open any door and hood.