13) Which of the following allow you to use multiple IPX networks on a single physical interface (下面哪一个允许你在单个物理接口上使用多个I P X网络)？
A. Secondary networks
B. Dynamic frame types
C. Subinterfaces
D. None. This is not supported.
14) Which IOS command allows you to view the router’s internal SAP database (哪一个I O S 命令允许你查看路由器的内部S A P数据库)？
A. SHOW SERV E R S
B. show ipx servers
C. servers
D. ipx servers
15) Which of the following kinds of information do you need to collect before you can configure IPX using IOS (你需要在用I O S配置I P X之前搜集下面各种信息中的哪一个)？
A. The number of NetWare servers on the network
B. The encapsulations in use
C. IPX network numbers
D. The IPX address of another router
16) What does this command do:
CISCO(CONFIG-IF)#IPX NETWORK 3 (这个命令的作用是什么： C I S C O ( C O N F I G -
IF)#IPX NETWORK3)：
A. Nothing. It is incomplete.
B. Sets up a static route to Network 3
C. Configures IPX Network 3 on this interface with the default frame type
D. Nothing. The router is in the wrong configuration mode.
17) What does this IOS command do?
IPX ROUTE 4 5.0000.8004.4563 FLOAT I N G - S TATIC (这个I O S命令的作用是什么I P X ROUTE 45.0000.8004.4563 FLOAT I N G - S TAT I C )？
A. Configures 4 static routes
B. Configures static SAP entries for servers of type 4
C. Configures a static route to network 4
D. Says that to get to network 5, you must go via network 4
18) In the command IPX ROUTE 4 5.0000.8004.4563 FLOAT I N G - S TATIC, what does the F L O AT I N G - S TATIC keyword on the end mean? ( 在命令IPX ROUTE 45.0000.8004.4563
F L O AT I N G.S TAT I C中，最后的F L O AT I N G.S TAT I C意味着什么)？
A. Set all static routes to floating
B. Allow this route to be overridden by a route received dynamically
C. Apply this route to all network numbers from 1 to 4
D. Lock this route so that it cannot be changed |
